Générateur Haute Tension DC 3V-6V Bis 1000kV Boost Step Up

This high-voltage module is made by using the principle of Tesla coil, and outputs high-voltage pulse high-voltage current. It is small in size, high in efficiency, and simple in peripheral circuits (just connect the switch and the battery can be used). The discharge intensity is violent.

Input voltage: DC 3V-6V
Input current: 2A-5A
High voltage type: pulse current type
Output voltage: about 200,000 volts (please pay attention to safety when using)
High voltage two-pole discharge distance: 10mm-20mm
Output high voltage line length: about 100mm
Input power cable length: about 100mm (red wire is positive)
Dimensions: Φ24*64mm
About the power supply: you can use a single 3.7V lithium battery or two in series, such as 18650 battery, an idle mobile phone battery (to remove the protection board, the recommended capacity is above 2000mAh) or NiCd/NiMH battery pack, 4V or 6V lead-acid battery etc.

This module is a finished module of a high-voltage inverter transformer/booster for scientific production. After inputting DC3V-7.2V voltage at the input end, a DC high voltage of about 200,000 volts (about 1-2 cm arc) can be obtained at the output end. , note that there is no ignition function

Wiring: The red wire is the positive pole of the power supply. The output is 2 high temperature and high pressure resistant silicone wires